•UV curing function after fiber coating
•The inlet and outlet of the curing furnace are located at both ends of the curing furnace
•The power of the curing furnace adopts a two-stage design (Low 50%/High 100%)
•Curing oven control mode: On/Standby/Off
•Capable of online detection of optical power
•RF detector detects microwave leakage function
•Fiber channel N₂/CDA atmosphere, adjustable flow/pressure, airflow direction from top to bottom
•The position of the curing oven can be easily adjusted to align the two ends of the curing oven, as well as the fiber optic inlet and outlet, with the fiber optic channel
| Indicator | Unit | Index |
|---|---|---|
| UV lamp dimensions | cm | 25 |
| Maximum lamp power density | W/cm | 240 |
| N₂/CDA gas flow rate | L/Min | 20 |
| N₂/CDA gas pressure | bar | 1 ~ 6 |
| Air supply flow requirement | m³/min | 8.9 |
| Power requirements | / | 380V/50Hz |
| Supply and exhaust air pressure difference range | Pa | 2750 |
| Jump point | MW/cm² | 5 |
| Early warning disconnect delay | S | 10 |
| Ambient relative humidity | / | 30% ~ 95% |
| Ambient working temperature | ℃ | 10 ~ 45 |
| Curing furnace power | Kw | 46 |
All rights reserved © 2026 Wuhan Hengtu Innovation Technology Co., LTD. Support:Intwho
